|
Results 1 - 10 from 19 for inlet compartment in 0.411 sec.
Inclined Plate Clarifiers
Inlet Compartment The inlet compartment of the IPS receives the raw water from the process. After entering through the non-clogging inlet nozzle the water is ... Complete shop assembly Adjustable effluent weir Oil skimming connections Options such as: Thickening compartment Flash Mixer / Flocculation Chambers Ladders / Stairs / Platforms Control Boxes / Motor Starters Ultrasonic ...
hydroquipinc.com
Heavy Equipment Pre-wash System
Inlet Compartment The inlet chamber will be comprised of a non-clog diffuser pipe to distribute the flow across the width of the CS chamber. The inlet compartment shall be of ... be positioned to prevent resuspension of settled solids. Oil Skimmer The clarifier compartment and the oil separation compartment will be provided with an adjustable rotatable pipe skimmer for gravity ...
hydroquipinc.com
More from this site
Aerobic Treatment Systems and how they work
Compartment causes most remaining suspended solids to drop out the bottom and re-enter the treatment cycle in the Aeration compartment. As additional wastewater enters the system via the Inlet, clarified effluent is then pushed by hydraulic action out of the Clarification Compartment through the Outlet (8 ...
www.hydro-action.com
Hydro-Action Industries AP Series
AP Series Feature Description AP Treatment Unit Platform-mounted OPSŪ Inlet High-level float Aeration Compartment Clarification Compartment Offset Service Access Air Distribution Manifold Outlet Flexible Air Lines Anchored Diffuser Assemblies ...
www.hydro-action.com
More from this site
McTighe Oil-Water Separators
This design requires an isolated base in the bottom of the compartment to prevent damage to the tank interior. For above ... separator to be vented to the atmosphere. In instances where it is desired to maintain inlet pressure though the separator, or to prevent separator damage if the possibility exists for pressurization ...
www.mctighe.com
Menardi - Baghouse Accessories [Opti-Coat™]
Inject ... be injected into duct at the suction side of the pressure system fan. Isolate each compartment and inspect filter bags for adequate pre-coat cake (approximately 1/16" thick) and check ...
www.menardifilters.com
Menardi: Information [Filtration Glossary - r]
A collector where cleaning is accomplished by stopping the dirty gas flowing into a compartment and backwashing the compartment with a low- pressure airflow. Particulate is usually collected on the inside of ... air-sealed star wheel with material buckets designed to provide an airtight seal between the inlet and discharge sides of the valve. ROTATING VANE ANEMOMETER A windmill-like device, small ...
www.menardifilters.com
More from this site
Glossary of Terms | Indoor Air | Air | US EPA
Top of page DAMPERS: Controls that vary airflow through an air outlet, inlet, or duct. A damper position may be immovable, manually adjustable or part of an automated ... for measuring radioactivity, often expressed as picoCuries per liter (pCi/L) of air. PLENUM: Air compartment connected to a duct or ducts. PM: Preventive Maintenance. POLLUTANT PATHWAYS: Avenues for distribution of ...
epa.gov
MicroSepTec - Engineers & Architects - System Overview
It is designed for optimum performance without any chemical addition. The settled solids are recirculated back to the first compartment. The fourth compartment is followed by a small effluent storage compartment which can be equipped with an optional gravity flow ...
microseptec.com
MicroSepTec - Regulators - System Overview
It is designed for optimum performance without any chemical addition. The settled solids are recirculated back to the first compartment. The fourth compartment is followed by a small effluent storage compartment which can be equipped with an optional gravity flow ...
microseptec.com
More from this site
The results are filtered
View all results for inlet compartment
|
